The Turners Select Drawbar Collet Chuck is an inexpensive quality chucking system for turning small projects like spinning tops, birdhouse finials and similar items where accuracy and tool accessibility are a priority. Many professional pen turners prefer using a drawbar collet chuck for holding pen mandrels as it eliminates the risk of off-center pen barrels and project tubes so you get the very best results possible.

To prevent injury, the theaded rod must be cut to length before powering on your lathe. Simply install the drawbar system on your lathe while it is unplugged, then cut the rod with a hacksaw so no more than 2" of rod extends past the collet chuck handwheel. Remove any sharp burrs with a file.

Available exclusively from Craft Supplies USA.

• Low profile design for greater tool access
• Quick and easy to operate
• Most accurate way to drive project mandrels
• Eliminates off-center barrels that look and fit poorly
• Won’t work loose while working
• Steel tightening knob
• Fits No. 2MT lathe spindles

Includes:
Tightening knob
15-1/4" section of 3/8" dia. threaded rod
1/4" Collet